Maretron Run Indicator Module RIM100 Manual de usuario descargar pdf (Pagina 12)

RIM100 User's Manual

Page 8 Revision 1.1

2.5.5 NMEA 2000

PGN Enable/Disable

The RIM100 is capable of transmitting NMEA 2000

messages (or PGNs) associated with

monitored load circuits. You may individually enable or disable each of these messages. You

may also change the rate of transmission of each of these messages if desired.

2.5.6 Restore Factory Defaults

Selecting this configuration option causes all stored parameters in the RIM100 to be reset to

the values they contained when the unit was manufactured.

2.5.7 Installation Description…

The RIM100, along with all other Level A certified NMEA devices, has two user-programmable

installation description fields. You may program these fields with information specific to the

device, such as date installed, the initials/name of the installer, the physical location of the

device, etc. This configuration option will allow you to program the values of these fields.

3 Maintenance

Regular maintenance is important to ensure continued proper operation of the Maretron

RIM100. Perform the following tasks periodically:

• Clean the unit with a soft cloth. Do not use chemical cleaners as they may remove

paint or markings or may corrode the RIM100 enclosure or seals. Do not use any

cleaners containing acetone, as they will deteriorate the plastic enclosure.

• Ensure that the unit is mounted securely and cannot be moved relative to the mounting

surface. If the unit is loose, tighten the mounting screws.

• Check the security of the cable connected to the NMEA 2000

connector, and tighten if

necessary.

• Check the security of all of the load connections on the top of the unit and tighten if

necessary.

4 Troubleshooting

If you notice unexpected operation of the Maretron RIM100, follow the troubleshooting

procedures in this section to remedy simple problems. If these steps do not solve your

problem, please contact Maretron Technical Support (refer to Section 6 for contact

information).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 18 19

Sin comentarios

Maretron Run Indicator Module RIM100 Manual de usuario Pagina 12