Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 102)

9.4.10.11 Changing Components on Favorite Screens

If you wish to change the data displayed by a particular component on the

favorite screen, its title, its component type, or its defined data ranges, select the

component on the favorite screen by pressing on it. When selected, a yellow

border will be displayed around the component. Then press the Edit button at the

bottom of screen.

A screenshot of a selected component is shown below.

Figure 25 – Selected Component in Screens Setup Mode

Pressing the Edit button on the bottom of the screen will open the Component

Editor with all the parameters of the component chosen.

9.4.10.12 Deleting Components from Favorite Screens

To remove a component from a particular favorite screen, select the component

on the favorite screen by pressing on it. When selected, a yellow border will be

displayed around the component. Then press the Delete button at the bottom of

screen, or press the Delete button on the keyboard.

A dialog will be displayed asking you to confirm the delete action.

9.4.10.13 Cutting Components from Favorite Screens

To remove a component from a particular favorite screen and place it on the

N2KView Clipboard, select the component on the favorite screen by pressing on

it. When selected, a yellow border will be displayed around the component. Then

press the Cut button at the bottom of screen, or Ctrl-X on the keyboard.

No confirmation dialog is displayed, as this action may be undone by pasting the

contents of the N2KView Clipboard back to the original position.

Revision 4.0.2 Page 102

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 ... 379 380

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 102