Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 270)

Longitude – The longitude of the reference position. This may be typed in as

<degrees>:<minutes> followed by an E or W. If the E or W is missing, East is

assumed. Moving the cursor to another field will reformat the contents of this

field. For the Anchor Watch Alert, this field may be left blank if the alert is

disabled, enabling the Alert to be created in advance of anchoring.

Get Current Position – Pressing or clicking on this button will transfer the

current GPS position into the Latitude and Longitude fields.

10.3.6.4.10 Inside Radius Alert

The Inside Radius Alert is similar to the Outside Radius Alert except that an alert

is activated if the vessel comes within a certain distance or radius of a reference

point (expressed as a longitude and latitude).

Figure 98 – Trigger Configuration - Inside Radius Alert

Accept Re-trigger Period – When you accept an alert, it will change to the

“Accepted” state, and annunciators that are sounding for that alert will stop

sounding. If the condition which caused the alert remains true after the amount of

time in this field, the alert will return to the “Active” state, and annunciators will

begin sounding again for that alert.

If a value of 0:00 is entered, then the alert will never re-trigger.

Inside Radius Alert Set – If the distance between the current GPS position and

the reference position falls below above the value in this field, the alert will

become active.

Revision 4.0.2 Page 270

1 2 ... 265 266 267 268 269 270 271 272 273 274 275 ... 379 380

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 270