
9.5.15 Inclinometer
The inclinometer is used to display the ship’s roll, as reported from the compass.
It is calibrated so that the red needle always points down. The User-defined title
appears at the top, and the units at the bottom right. The component is square.
An example of an inclinometer is shown below.
Figure 46 – Inclinometer Component Example
Min Max Markers may be added to an Inclinometer Component by clicking on a
check box in the Component Editor. The markers show the limits of the needle
movement in either direction. These marks are associated with the control itself.
That means that if two controls are displaying the same data, each will maintain
its own values for the min max marks, and they can be reset independently.
Figure 47 – Inclinometer with Min Max Marks
Revision 4.0.2 Page 133
Comentarios a estos manuales