Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 254)

10.3.6.2.2 Operating Mode(s)

In this field, you may choose in which vessel operating modes, Moored,

Underway, Anchored, User1, or User 2, this alert is enabled. You may choose

any or all of these modes. The default is to have all five modes enabled. If the

alert is Active or Accepted (i.e. the condition causing the alert is still present) and

the check box for the current operating mode is disabled, a warning will be

shown.

10.3.6.3 Alert Editor Buttons

Figure 85 - Alert Editor Buttons

The Alert Editor Buttons are located at the bottom of the Alert Editor. The area

above the buttons is used to communicate messages to the user regarding

incomplete fields in the editor.

10.3.6.3.1 Save and Test

Pressing the Save and Test Button will first save the alert in the database, and

then issue a command to simulate the transition of the monitored value to a value

that would activate the alert, giving a full test of all the actions associated with the

Alert. The word “Test” will be pre-pended to all descriptions of the alert, including

email titles. Note that pressing the Test button will. The alert will only become

active after the Set Delay has expired.

While the Test is in progress, the Test button changes to a Stop Test button,

which can be used to stop the test. The alert will transition to the Inactive state

after the Clear Delay has expired.

10.3.6.3.2 Actions

This button opens the Alert Action Editor for the chosen alert (see section

10.3.7).

10.3.6.3.3 Save

Pressing the Save button will save the alert Information in the database and exit

the editor. The Save button will be grayed out if the editor contains inconsistent

or missing information.

Revision 4.0.2 Page 254

1 2 ... 249 250 251 252 253 254 255 256 257 258 259 ... 379 380

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 254