Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 354)

100

101

13.6.2 Configuring Sources

The top portion of the screen shows the Sources being monitored. The Sources

are labeled “Source 0”, “Source 1”, “Source 2”, and “Source 3”. If the Source has

been set to an ACM100, and the ACM100 supplies a label, the label on the

control will be changed to that supplied by the ACM100.

The Digital Control shows both the current reported by the ACM100, and the

Load Shedding Current. A dash for the Load Shedding Current implies that the

source is not providing a current that can be monitored for load shedding. If the

user disables the source, it will show Disabled.

The LED on the Digital Control will show red when the reported current exceeds

the Load Shedding Current, yellow when the reported current is within 10% of the

Load Shedding Current and green when less than 90%.

The Source is configured my pressing the Edit Button, and may be enabled /

disabled from this dialog.

Figure 110 – Load Shed Source Dialog

The Digital Control shows the current reported by the ACM100.

The User can set the parameter to choose the correct ACM100 (Device Type

and ACM instance number) and the Load Shedding Current.

Revision 4.0.2 Page 354

1 2 ... 349 350 351 352 353 354 355 356 357 358 359 ... 379 380

Comentarios a estos manuales

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 354

Comentarios a estos manuales

Relacionado con productos y manuales para Redes Maretron Alarm Module ALM100