
10.3.5 Alerts Setup Dialog
The Alerts Setup Dialog allows you to create new alerts or delete or re-configure
existing alerts. Also, you may change the operating mode of the vessel, enabling
you to easily enable and disable groups of alerts.
Figure 80 – Alert Setup Dialog
Alert Operating Mode – In this section, you may select the vessel’s operating
mode from one of the following choices:
• Disabled – This selection disables all alerts on the vessel. No alerts will be
generated for any reason.
• Moored – This selection sets the vessel’s operating mode to “Moored”. All alerts
which are enabled in “Moored” mode will be enabled. All other alerts will be
disabled.
• Anchored – This selection sets the vessel’s operating mode to “Anchored”. All
alerts which are enabled in “Anchored” mode will be enabled. All other alerts will
be disabled.
• Underway – This selection sets the vessel’s operating mode to “Underway”. All
alerts which are enabled in “Underway” mode will be enabled. All other alerts will
be disabled.
Revision 4.0.2 Page 247
Comentarios a estos manuales