Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 267)

Figure 96 - Trigger Configuration – Outside Radius Alert

Accept Re-trigger Period – When you accept an alert, it will change to the

“Accepted” state, and annunciators that are sounding for that alert will stop

sounding. If the condition which caused the alert remains true after the amount of

time in this field, the alert will return to the “Active” state, and annunciators will

begin sounding again for that alert.

If a value of 0:00 is entered, then the alert will never re-trigger.

Outside Radius Alert Set – If the distance between the current GPS position

and the reference position rises above the value in this field, the alert will become

active.

Set Delay – The distance between the current GPS position and the reference

position must rise above the Outside Radius Alert Set value for longer than the

time in this field in order for an alert to become active.

Outside Radius Alert Clear – If the alert is active and the distance between the

current GPS position and the reference position falls below the value in this field,

the alert will become inactive.

Clear Delay – The distance between the current GPS position and the reference

position must fall below the Outside Radius Alert Clear value for longer than the

time in this field in order for an alert to become inactive.

Latitude – The latitude of the reference position. This may be typed in as

<degrees>:<minutes> followed by an N or S. If the N or S is missing, North is

assumed. Moving the cursor to another field will reformat the contents of this

field.

Revision 4.0.2 Page 267

1 2 ... 262 263 264 265 266 267 268 269 270 271 272 ... 379 380

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 267