Maretron Alarm Module ALM100 Manual de usuario Pagina 238

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 380
  • Tabla de contenidos
  • SOLUCIÓN DE PROBLEMAS
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 237
10.2 Alert Concepts
10.2.1 Alert Types
An alert is a signal to a user that there is either an alarm or warning condition
requiring user intervention.
There are two classes of alerts, which are distinguished by their severity:
Alarm An alarm is a type of alert announcing a condition requiring immediate
attention or user intervention. Alarms are shown in red, and always appear to the
left of warnings in the Alert Ticker and above warnings on the Alert Screen.
WarningA warning is a type of alert announcing a condition requiring non-
immediate attention for precautionary reasons. Warnings are shown in yellow, and
always appear to the right of Alarms in the Alert Ticker and below alarms on the
Alert Status Screen.
10.2.2 Alert Terminology
The following alert terminology is used in N2KView.
AcceptThe user action of acknowledging the existence of an alert. Alerts are
only accepted when they are Active
Cancel The user action of removing an alert from the list of displayed alerts.
Alerts may only be cancelled if the condition causing the alert has been removed.
Acknowledge From version 3.6.2, the terms Accept and Cancel have been
replaced by Acknowledge to conform to changes in the IMO code on Alarms and
Indicators. An Alert must be Acknowledged by the user, and this action can
happen when the Alert is Active or the condition causing the alert has been
removed without the Alert being previously Acknowledged.
Clear An alert is cleared when the condition causing the alert is removed.
Trigger An alert is triggered when the condition monitored by the alert is met.
10.2.3 Alert Priority
Each alert has a priority which you can define, ranging from 0 to 4000 with 0 the
highest or most important priority and 4000 the lowest or least important priority.
Alerts can be ordered many different ways on the Alerts Screen. For example,
ordering by priority is done by clicking on the column header entitled Priority or
listing the log entry chronologically is done by clicking on the column header
entitled time. Data can be sorted on any column by clicking the column heading.
Revision 4.0.2 Page 238
Vista de pagina 237
1 2 ... 233 234 235 236 237 238 239 240 241 242 243 ... 379 380

Comentarios a estos manuales

Sin comentarios