
9.4.4 Configuration Dialog
Pressing the “Configuration” button causes the “Configuration” dialog to be
displayed. This window allows you to configure the parameters that are used in
N2KView and if N2KView is running on the MBB100 or DSM800 it allows
configuration of some system parameters.
A screenshot of the “Configuration” dialog showing the Configuration tab is
shown below.
Figure 18 – Configuration Dialog
9.4.4.1 Configuration Tab
The fields in this section are used to control the configuration of the screen.
9.4.4.1.1 Label
N2KView programs can be given a label so that an installation having multiple
copies of N2kView can distinguish between them. This is important for the alert
management, when the identity of the station that responds to an alert can be
shown. The label is initially set by the user in the Initial Startup Warning dialog.
Revision 4.0.2 Page 71
Comentarios a estos manuales