Maretron Alarm Module ALM100 Manual de usuario descargar pdf (Pagina 269)

Figure 97 - Trigger Configuration – Anchor Watch Alert

Accept Re-trigger Period – When you accept an alert, it will change to the

“Accepted” state, and annunciators that are sounding for that alert will stop

sounding. If the condition which caused the alert remains true after the amount of

time in this field, the alert will return to the “Active” state, and annunciators will

begin sounding again for that alert.

If a value of 0:00 is entered, then the alert will never re-trigger.

Anchor Watch Alert Set – If the distance between the current GPS position and

the reference position rises above the value in this field, the alert will become

active.

Set Delay – The distance between the current GPS position and the reference

position must rise above the Outside Radius Alert Set value for longer than the

time in this field in order for an alert to become active.

Anchor Watch Alert Clear – If the alert is active and the distance between the

current GPS position and the reference position falls below the value in this field,

the alert will become inactive.

Clear Delay – The distance between the current GPS position and the reference

position must fall below the Anchor Watch Alert Clear value for longer than the

time in this field in order for an alert to become inactive.

Latitude – The latitude of the reference position. This may be typed in as

<degrees>:<minutes> followed by an N or S. If the N or S is missing, North is

assumed. Moving the cursor to another field will reformat the contents of this

field. For the Anchor Watch Alert, this field may be left blank if the alert is

disabled, enabling the Alert to be created in advance of anchoring.

Revision 4.0.2 Page 269

1 2 ... 264 265 266 267 268 269 270 271 272 273 274 ... 379 380

Sin comentarios

Maretron Alarm Module ALM100 Manual de usuario Pagina 269